1979 FORD MUSTANG

7 recalls, 0 complaints - 2 TSBs

FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP

Defect Description

INTERCONTINENTAL AUTO PARTS IS RECALLING 1,937 FUEL FILTERS, P/NOS ALG 44/1 AND PUROLATOR F10024, SHIPPED BETWEEN JANUARY 14 AND FEBRUARY 13, 2008, SOLD FOR USE ON THE VEHICLES LISTED ABOVE. THE FILTER'S OUTLET CAP MAY NOT BE SECURELY CRIMPED TO THE HOUSING. THIS COULD RESULT IN A SEPARATION OF FI... Read more

Consequence

IF THIS CONDITION OCCURS WHILE ATTEMPTING TO START THE VEHICLE, A NO START CONDITION MAY RESULT AND FUEL MAY BE PUMPED ONTO THE GROUND. IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION, THE ENGINE MAY STOP DUE TO INADEQUATE FUEL SUPPLY. IF AN IGNITION SOURCE WERE PRESENT, FUEL LEAKAGE MAY RESULT IN A... Read more

Remedy

INTERCONTINENTAL WILL REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING MARCH 2008. OWNERS MAY CONTACT INTERCONTINENTAL AT 800-451-2593.

1,937 vehicles affected

Manufacturer: INTERCONTINENTAL AUTO PARTS

FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP

Defect Description

CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTA... Read more

Consequence

A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.

Remedy

FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.

34,000 vehicles affected

Manufacturer: FEDERAL-MOGUL CORPORATION

SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES

Defect Description

THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Remedy

DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.

82,000 vehicles affected

Manufacturer: FORD MOTOR COMPANY

ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN

Defect Description

WITH THE ENGINE OPERATING AT HIGH SPEED, THE PLASTIC ENGINE FAN FINGER GUARDS MAY CONTACT THE ENGINE FAN AND BREAKAGE OF THE GUARD MAY OCCUR. THIS COULD CAUSE FRAGMENTS OF THE FINGER GUARD TO SCATTER.

Remedy

TWO GUARD SUPPORTS AND TWO ADDITIONAL FASTENERS WILL BE INSTALLED. IF THE FAN GUARD HAS BEEN DAMAGED, THE GUARD AND FAN WILL BE REPLACED AT NO COST TO OWNER.

2,700 vehicles affected

Manufacturer: FORD MOTOR COMPANY

STEERING: STEERING WHEEL/HANDLE BAR

Defect Description

AN INCORRECT STEERING GEAR FLANGE MAY HAVE BEEN INSTALLED, WHICH MAY SLIP AND CAUSE EVENTUAL LOSS OF STEERING CONTROL.

Remedy

INSPECTION FOR AND REPLACEMENT OF INCORRECT STEERING GEAR FLANGES WILL BE DONE AT NO COST TO OWNER.

16,000 vehicles affected

Manufacturer: FORD MOTOR COMPANY

ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN

Defect Description

THE INVOLVED VEHICLES ARE EQUIPPED WITH FLEXIBLE COOLING FAN BLADES THAT MAY CRACK WHEN SUBJECTED TO HIGH ENGINE SPEED OPERATING CONDITIONS. FAN BLADE CRACKING CAN LEAD TO FRAGMENTS SEPARATING FROM THE FAN.

Remedy

THE DEALER WILL REPLACE THE EXISTING COOLING FAN AT NO COST TO OWNER.

6,750 vehicles affected

Manufacturer: FORD MOTOR COMPANY

STEERING:COLUMN

Defect Description

THE TILT STEERING COLUMNS ON THE INVOLVED VEHICLES CONTAIN IN-PROCESS TEMPORARY ALIGNMENT PINS RATHER THAN THE PERMANENT PRESS-FIT PIVOT PINS. THE TEMPORARY PINS ARE SLIGHTLY UNDERSIZED AND COULD SEPARATE FROM THE STEERING COLUMN DURING VEHICLE OPERATION. THIS CAN CAUSE STEERING WHEEL LOCKUP.

Remedy

THE DEALER WILL INSTALL A PERMANENT PIVOT PIN IN THE STEERING COLUMN WITHOUT CHARGE TO OWNER.

59 vehicles affected

Manufacturer: FORD MOTOR COMPANY

No complaints found for this vehicle.

Technical Service Bulletins, 1979 FORD MUSTANG

2 manufacturer communications from 2 unique bulletins. TSBs describe known problems and recommended fixes from the manufacturer.

Most Affected Components

Component	Bulletins
061320 ENGINE AND ENGINE COOLING:ENGINE:OTHER FUEL TYPES:TURBO/SUPERCHARGER	1
034520 SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:PADS	1

061320 ENGINE AND ENGINE COOLING:ENGINE:OTHER FUEL TYPES:TURBO/SUPERCHARGER

UNKNOWN

034520 SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:PADS

UNKNOWN

NHTSA Safety Investigations, FORD MUSTANG

Investigations opened by NHTSA into potential safety defects. These are separate from recalls and may or may not result in a recall.

PE, Closed , Model Year: 2011

Inability to shift gears on acceleration

The Office of Defects Investigations (ODI) analyzed complaint data provided by Ford as well as complaints submitted to ODI from consumers.In total, there were 364 unique reports indicating various shift quality issues while driving.Ford identified several factors that may contribute to shift quality... concerns in the subject vehicles, including cold transmission, clutch stay-out at high engine speeds, gear clash or grinding, and gradual loosening of clutch plate bolts in some early production vehicles.The largest percentage of complaints indicated higher than expected shift efforts in cold ambient temperatures.These complaints were related to transmission fluid viscosity and the higher shift efforts resolved themselves with the drivetrain warming.Ford published technical service bulletin TSB 11-3-18 to inform technicians that a lower viscosity fluid was available for use to address the cold shift issues.The clutch stay-out condition typically occurs at engine speeds greater than 4000 rpm.It does not prevent the selection of any gear, but may delay clutch re-engagement depending on how long the driver maintains the higher engine speed.Ford identified rotating inertia of the clutch components as the root cause and replacement clutch pedal parts were made available under Ford TSB 10-19-4.A number of reports alleged increasing difficulty selecting gears along with gear clash or grinding.Grinding or notchy gear shifts may be caused by gradual loosening of clutch plate fasteners, which is promoted by certain aggressive shifting.This condition is progressive in nature and initially results in symptoms related to shift quality/feel.Clutch plate bolt loosening will not result in inability to select any gear unless the progressive symptoms are ignored until complete clutch failure occurs.ODI?s analysis identified only five complaints alleging an inability to shift into gear due to loose clutch plate bolts.None of these resulted in a stall and gear shifting could occur before engine start.A revised fastener was designed and implemented in production and is available for service through a special service message.There is no indication of loss of motive power or unreasonable safety risk associated with the alleged defect in the subject vehicles.This preliminary evaluation is closed.Read more

EA, Closed , Model Year: 2003

ACCELERATOR PEDAL INTERFERENCE

ON APRIL 3, 2006, FORD MOTOR COMPANY SUBMITTED A DEFECT INFORMATION REPORT TO NHTSA CONCERNING A DEFECT CONDITION THAT COULD RESULT IN INTERFERENCE BETWEEN THE ACCELERATOR PEDAL AND FLOOR CARPETING IN APPROXIMATELY 19,140 MODEL YEAR 2003 AND 2004 MUSTANG COBRA VEHICLES (FORD RECALL NO. 06S43/NHTSA R... Read more

PE, Closed , Model Year: 2003

ACCELERATOR PEDAL INTERFERENCE

PE05-038 WAS OPENED ON JULY 7, 2005, WITH 11 CONSUMER COMPLAINTS TO ODI ALLEGING INCIDENTS OF THROTTLE STICKING DUE TO ACCELERATOR PEDAL INTERFERENCE WITH THE CARPET.ODI HAS RECEIVED AN ADDITIONAL 24 COMPLAINTS SINCE THE PE WAS OPENED.DURING PE05-038, FORD SUPPLIED COMPLAINT AND WARRANTY INFORMATION... Read more

PE, Closed , Model Year: 1998

FIRES IN THE CENTER CONSOLE