CESSNA 172S
Boyd, TX, July 14, 2009
Event Information
| Date | July 14, 2009 |
| Event Type | ACC |
| Location | Boyd, TX |
| Country | USA |
| Coordinates | 33.06028, -97.61361 |
| Highest Injury | MINR |
| NTSB Number | CEN09LA442 |
| Event ID | 20090715X84438 |
Aircraft
| Make | CESSNA |
| Model | 172S |
| Registration # | N2446F |
| Category | AIR |
| FAR Part | 091 |
| Aircraft Damage | SUBS |
Conditions
| Light Condition | DAYL |
| Weather | VMC |
Injuries
| Fatal | 0 |
| Serious | 0 |
| Minor | 1 |
| None | 0 |
| Total Injured | 1 |
Event Location
Probable Cause
A total loss of engine power due to the pilot's improper leaning procedures, resulting in a forced landing and collision with a fence.
Full Narrative
On July 14, 2009, at 1745 central daylight time, a Cessna 172S, N2446F, registered to a private owner and operated by Sky Mays Flight Academy, experienced a total loss of engine power and made a forced landing to a pasture in the vicinity of Boyd, Texas. The instructional flight was conducted under the provisions of 14 Code of Federal Regulations Part 91 and no flight plan was filed. Visual meteorological conditions prevailed and the airplane sustained structural damage to the airframe. The student pilot reported minor injuries. The flight originated from Fort Worth Meacham International Airport (FTW), Fort Worth, Texas at 1732.
The pilot stated he conducted a preflight inspection, started the engine, completed the required checklist items, taxied to the run up area and completed an engine run up, to include leaning the mixture and no anomalies were noted. He departed and climbed to 2,000 feet mean sea level when the engine started running rough and popping. The engine RPM dropped from 2,200 to 2,000 RPM without the throttle being moved. The pilot thought he had not leaned the engine to maximum power so he used the engine lean assist and "leaned it to peak temperature (getting an open box) on either cylinder 1 or 4 and enriched mixture to -30 degrees when the engine roughness and popping increased and the RPM started going down fast....I realized it was engine failure."
Examination of the crash site by an inspector from the Federal Aviation Administration revealed the landing gear tracks began 800 feet east of the airplane final resting place. The aircraft traveled through 600 feet of pasture before colliding with a fence, becoming airborne, crossing over a gully, and a tree line, before the right horizontal stabilizer struck a tree and the airplane impacted a berm on the opposite side of a pond. Examination of the airframe, flight controls, engine assembly and accessories revealed no anomalies.
About This NTSB Record
This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.