EQUIPMENT
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
121,680 vehicles affected
SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DRUM:WHEEL CYLINDERS
EXCESSIVE ENLARGEMENT OF THE WHEEL CYLINDER PILOT HOLE IN THE REAR BRAKE BACKING PLATE COULD ALLOW THE WHEEL CYLINDER TO ROTATE AND CAUSE LOSS OF BRAKE FLUID. CONSEQUENCE OF DEFECT: A LOSS OF BRAKE FLUID LEADS TO LOSS OF REAR BRAKE ACTION, CREATING THE POTENTIAL FOR AN ACCIDENT. FRONT BRAKES WOULD REMAIN OPERATIONAL.
Remedy: ADD A PART TO PREVENT WHEEL CYLINDER FROM ROTATING.
1,810,000 vehicles affected
POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT
REAR AXLE ASSEMBLY MAY HAVE AXLES THAT WERE IMPROPERLY MANUFACTURED. THIS CONDITION MAY RESULT IN SEPARATION OF THE AXLE SHAFT AND WHEEL ASSEMBLY FROM THE VEHICLE.
Remedy: THE DEALER WILL INSPECT THE REAR AXLE TO DETERMINE WHETHER IT WAS MANUFACTURED AT THE BUFFALO PLANT. IF SO, THEY WILL MAKE AXLE MEASUREMENTS AND IF NECESSARY REPLACE OR MODIFY AFFECTED AXLE COMPONENTS WITHOUT CHARGE.
3,100,000 vehicles affected
SUSPENSION:REAR
THE BOLTS THAT ATTACH THE LOWER REAR CONTROL ARM TO THE FRAME MAY FRACTURE. THE REAR CONTROL ARM SUPPORTS AND POSITIONS THE REAR AXLE. FRACTURE OF THE BOLTS WOULD ALLOW THE CONTROL ARM TO DROP FREE.
Remedy: BOTH REAR CONTROL ARM ATTACHMENT BOLTS WILL BE REPLACED WITHOUT CHARGE.
5,821,160 vehicles affected
VISIBILITY:GLASS, SIDE/REAR
THE ELECTRO-CLEAR REAR WINDOW DEFOGGERS CONTAIN A DEFECT WHICH CAUSES THE GLASS TO SHATTER WITHOUT IMPACT DURING OR SOME TIME AFTER USE OF THE DEFOGGER. VERTICAL ELECTRICAL STRIPS MAY DETERIORATE AND CAUSE HOT SPOTS THAT CAN RESULT IN BREAKAGE OF THE REAR GLASS.
Remedy: VEHICLES WILL BE INSPECTED FOR PRESENCE OF A PARTICULAR WEATHERSTRIP. IF PRESENT, A LAYER OF A SPECIAL CONDUCTIVE EPOXY WILL BE ADDED TO THE VERTICAL BAR ON THE REAR WINDOW GLASS. THIS EPOXY IS A NEW CONDUCTIVE MATERIAL WHICH WILL NOT REACT WITH THE WEATHERSTRIP.
67,350 vehicles affected
SEATS:FRONT ASSEMBLY:HEAD RESTRAINT
THE INVOVLED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACTS". INCORRECT HEAD RESTRAINTS MAY HAVE BEEN INSTALLED.
Remedy: DEALER WILL INSPECT AND, IF NECESSARY, INSTALL NEW HEAD RESTRAINTS AT NO COST TO OWNER.
491 vehicles affected
EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH
ON THE INVOLVED VEHICLES THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH WHICH IS OPERATED BY THE BRAKE PEDAL MAY HAVE BEEN ASSEMBLED WITH AN INCORRECT LUBRICANT ON THE ACTUATING PLUNGER. THIS CAN CAUSE THE REAR BRAKE STOPLIGHTS TO BECOME INOPERATIVE AND THE CRUISE CONTROL, IF ACTIVATED, TO STAY ELECTRICALLY ENGAGED.
Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH AT NO COST TO OWNER.
15,328 vehicles affected
SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:CALIPER
AN INCORRECT FLUID WAS USED AS AN ASSEMBLY AID (LUBRICATION) DURING INSTALLATION OF THE PISTON SEAL IN FRONT BRAKE CALIPERS WHICH WERE INSTALLED IN 10.5" X 1" DISC BRAKE ASSEMBLIES USED ON "A" SERIES CARS. THE INCORRECT FLUID ATTACKS THE PISTON SEAL AND CAUSES THEM TO SWELL AND DETERIORATE.
Remedy: DEALER WILL REPLACE THE BRAKE CALIPER PISTON SEALS.
46 vehicles affected