SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS
REAR BRAKE HOSES MAY HAVE BEEN MANUFACTURED INCORRECTLY WHEN THE METAL END FITTINGS WERE INSTALLED. SOME REAR BRAKE HOSES MAY SEPARATE FROM THE METAL END FITTINGS WHEN SUBJECTED TO THE PULLING FORCE SPECIFIED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD 106, "BRAKE HOSES".
Remedy: THE DEALER WILL INSPECT AND REPLACE, IF NECESSARY, THE REAR BRAKE HOSES AT NO CHARGE TO OWNERS.
15,495 vehicles affected
FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP
UNDER CERTAAIN CONDITIONS, THE HOSE CLAMPS ON THE FUEL TANK FILLER PIPE AND FUEL TANK FILLER VENT PIPE COULD FRACTURE. THE FRACTURE OF THESE CLAMPS COULD CAUSE FUEL LEAKAGE AT ANY OF THE FOUR PIPE TO HOSE CONNECTIONS. LEAKAGE CAN OCCUR DURING REFUELING, OR WHILE DRIVING, IF THE FUEL TANK IS ABOVE 3/4 FULL.
Remedy: DEALER WILL INSPECT AND REPLACE THE HOSE CLAMPS ON THE FUEL TANK FILLER PIPE AND VENT PIPE AT NO COST TO OWNER.
519,329 vehicles affected
POWER TRAIN:CLUTCH ASSEMBLY:PEDAL/HAND LEVER(MOTORCYCLE)
THE CLUTCH CABLE MAY RUB AGAINST THE MASTER CYLINDER BRAKE PIPE WHEN THE CLUTCH PEDAL IS OPERATED. CONTINUED OPERATION OF THE VEHICLE MAY RESULT IN WEAR THROUGH OF THE INSULATION ON THE CLUTCH CABLE. THE RESULTING METAL ON METAL CONTACT COULD LEAD TO FAILURE OF THE BRAKE PIPE, LOSS OF BRAKE FLUID, AND PARTIAL LOSS OF BRAKE ACTION.
Remedy: DEALER WILL INSPECT AND, IF NECESSARY, CORRECT SYSTEM BY PROVIDING A MINIMUM 1/2 INCH CLEARANCE BETWEEN CLUTCH CABLE AND BRAKE PIPE TO AVOID METAL ON METAL CONTACT.
4,987 vehicles affected
ENGINE STALLS WHEN CORNERING OR WAITING AT INTERSECTIONS WITH STOP LIGHTS WHENEVER AMBIENT AIR TEMPERATURES EXCEED 85 DEGREES F*. MUST WAIT LONGER AS TEMPS. INCREASE. *AK
THE SEAT BELTS DID NOT WORK WHILE ACCIDENT OCCURRED, FOUR PEOPLE INJURED AND ONE DEATH DUE TO SEAT BELT FAILURE.
4 injured
1 deaths
BRAKE CALIPERS LOCKED UP. *SD