CIRRUS DESIGN CORP SR20
Cleveland, TN — March 26, 2017
Event Information
| Date | March 26, 2017 |
| Event Type | ACC |
| NTSB Number | ERA17CA137 |
| Event ID | 20170326X55937 |
| Location | Cleveland, TN |
| Country | USA |
| Coordinates | 35.21361, -84.79972 |
| Airport | CLEVELAND RGNL JETPORT |
| Highest Injury | NONE |
Aircraft
| Make | CIRRUS DESIGN CORP |
| Model | SR20 |
| Category | AIR |
| FAR Part | 091 |
| Aircraft Damage | SUBS |
Conditions
| Light Condition | DAYL |
| Weather | VMC |
Injuries
| Fatal | 0 |
| Serious | 0 |
| Minor | 0 |
| None | 4 |
| Total Injured | 0 |
Event Location
Probable Cause
The flight instructor's inadequate supervision, which resulted in a premature rotation for a no-flap takeoff and subsequent loss of airplane control during the initial climb.
Full Narrative
The flight instructor was conducting an instructional flight in the airplane, which was owned by the student pilot. The flight instructor reported that he did not notice that the student pilot did not set the flaps to the appropriate position for takeoff, as required on the before takeoff checklist. Immediately after rotation, during the initial climb, the student pilot had difficulty maintaining directional control. The flight instructor took control of the airplane about 10 ft above the runway, the stall warning annunciator was audible, and the airplane began sinking. The flight instructor pushed the nose over but was unable to recover before the airplane landed hard and then departed the right side of the runway. The landing gear dug into the mud, the airplane then spun around and the nose gear and left main landing gear collapsed, which resulted in substantial damage to the elevator and vertical stabilizer. The flight instructor reported that there were no preimpact mechanical failures or malfunctions with the airplane that would have precluded normal operation.
About This NTSB Record
This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.