Technical Service Bulletins
Search 172,063 manufacturer communications covering 879 vehicle makes from 1955 to 2025.
Showing 891 bulletins for PREVOST
SCI18-46
Dec 21, 2018
353000 EQUIPMENT:ELECTRICAL
This Service Center Instructions explains how to install the Prevost Ultimate Entertainment System
IS-18078
Dec 13, 2018
150000 SEAT BELTS
This instruction sheet shows how to install reinforcement for seat belts in the front slide-out.
SP18-49
Dec 11, 2018
010000 STEERING
On the vehicles affected by this bulletin, an inspection of the upper steering column universal joint must be performed.
Wb17-14B
Dec 11, 2018
110000 ELECTRICAL SYSTEM
On the vehicles affected by this bulletin, the power cable stud adapter on the alternator must be inspected and if needed, replaced.
Sp18-39A
Dec 10, 2018
060000 ENGINE AND ENGINE COOLING
This Special Bulletin explains how to perform the replacement of the SCR tank, when authorized.
IS-13009C
Dec 3, 2018
017210 STEERING:LINKAGES:DRAG:LINK:CONNECTION
This instruction sheet explains how to install and adjust drag link # 660699
IS-18025
Nov 22, 2018
060000 ENGINE AND ENGINE COOLING
This instruction sheet shows how to replace kneeling level sensor #21643575 by sensor #22194741.
WB18-43
Nov 22, 2018
100000 POWER TRAIN
This Warranty Bulletin explains how to update the VECU (Vehicle Electronic Control Unit) parameters to allow auto engine brake function with the I-Shift transmission.
IS-18907
Nov 20, 2018
353000 EQUIPMENT:ELECTRICAL
This instruction sheet explains how to install hatches with fan on X3 vehicles.
IS-18905
Nov 20, 2018
350000 EQUIPMENT
This instruction sheet explains how to install hatches with fan on H3 vehicles.
IS-17910
Nov 13, 2018
350000 EQUIPMENT
This instruction sheet explains how to replace the message center display (MCD)
MI18-45
Nov 12, 2018
350000 EQUIPMENT
This Maintenance Information presents the new maintenance inspections and new method to adjust toe-in of vehicles equipped with new tie rod 610052.
SP18-39
Nov 7, 2018
063140 ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CATALYTIC CONVERTOR
This Special Bulletin explains how to perform the replacement of the SCR tank, when authorized.
SP18-307
Nov 5, 2018
060000 ENGINE AND ENGINE COOLING
On the vehicles affected by this bulletin, the Bitzer compressor shaft seal must be replaced. Additionally, the compressor oil must be renewed and the oil quantity increased by 10oz (300ml).
sp18-35
Oct 31, 2018
350000 EQUIPMENT
On vehicles with active code P20EE, perform the following checklist and operations.
IS12010
Oct 30, 2018
350000 EQUIPMENT
This instruction sheet explains how to replace the left bell crank using kit 161349
Sp18-302
Oct 4, 2018
110000 ELECTRICAL SYSTEM
On the vehicles affected by this bulletin, install a pressure switch into the front service compartment to send a faster signal to the Allison transmission to switch to neutral at stop.
MI18-28
Sep 24, 2018
162300 STRUCTURE:BODY:DOOR
On the vehicles affected by this bulletin, the compressor door may be adjusted for proper fit following the procedure below.
SP18-308A
Sep 18, 2018
357100 EQUIPMENT:APPLIANCE:AIR CONDITIONER
On the vehicles affected by this bulletin, add 300ml of oil in the Bitzer A/C compressor as per production retrofit R18053.
WB18-04
Sep 7, 2018
118000 ELECTRICAL SYSTEM:SOFTWARE
On the vehicles affected by this bulletin, update EMS and ACM software to the latest version available.
SP18-306
Sep 7, 2018
118000 ELECTRICAL SYSTEM:SOFTWARE
On the vehicles affected by this bulletin, update EMS and ACM software to the latest version available.
IS-18904
Aug 24, 2018
284100 BACK OVER PREVENTION: SENSING SYSTEM: CAMERA
This procedure shows how to install a rear camera.
SP18-305A
Aug 22, 2018
170000 LATCHES/LOCKS/LINKAGES
On the vehicles affected by this bulletin, apply thread locker on the double door latch pins internal threads
MI18-27B
Aug 13, 2018
110000 ELECTRICAL SYSTEM
This maintenance information presents the Amerex fire suppression system, and its recommended maintenance
WB18-01A
Jul 18, 2018
160000 STRUCTURE
On the vehicles affected by this bulletin, it is necessary to add two metal reinforcement plates to all the parcel rack door supports that are holding a door gas shock.