Smoke Detectors

CPSC Recall #77-083 - July 31, 1977

Recall Summary

Recall Number77-083
Recall DateJuly 31, 1977
Remedy TypeReplace

Product

Smoke Detectors

Description

WASHINGTON, D.C. (Aug. 1) -- BRK Electronics, in cooperation with the U.S. Consumer Product Safety Commission (CPSC), today issued a second notice of the recall of all BRK SS749 series smoke detectors manufactured before September 26, 1975. The first notice of this recall was issued January 25, 1977, but between 85-90,000 of these smoke detectors have not been located. The recall was begun voluntarily by BRK when the company discovered that incorrectly- rated resistors were used in the SS749 series smoke detectors produced from March 1974 to September 26, 1975. These resistors could fail, making the unit inoperable, and may under certain circumstances cause a fire inside the detector. Although the detector is enclosed in self-extinguishing plastic, the units are being recalled as a precautionary measure. According to BRK, all distributors who purchased the detectors have been contacted and with the company's help have been notifying the contractors who installed the detectors to organize factory supervised replacement programs. The units subject to this recall are 110 volt AC-powered detectors which sold for a suggested retail price of $39.95. No battery-powered detectors are involved. Some models were manufactured with ordinary power cords (line cord) which plug into wall outlets, others have pigtail leads (hard wire) for installation directly into the household circuit The units subject to this recall are 110 volt AC-powered detectors which sold for a suggested retail price of $39.95. No battery-powered detectors are involved. Some models were manufactured with ordinary power cords (line cord) which plug into wall outlets, others have pigtail leads (hard wire) for installation directly into electric wiring. The detectors were marketed by BRK, American Machine & Foundry (AMF), I-T-E Imperial Corporation (I-T-E) and Sears, Roebuck & Company (Sears). They have the following model numbers: BRK SS749AC (hard wire) SS749ACS (hard wire) SS749L (line cord) SS749SL (line cord) AMF 2000AC (hard wire) 2000ACL (line cord) I-T-E IT0l-AC (hard wire) Sears 9-57049 (hard wire) 9-57047 (line cord) 9-57048 (line cord) Homeowners who suspect they have one of these smoke detectors are urged to check the model number on their unit. (Caution: Before inspecting hard-wired detectors, electrical power to the unit must be turned off at the fuse box or circuit breaker; line cord detectors must be unplugged before inspection). Once the power is off, remove the cover and examine the side of the plastic base for a label which contains the model number. Anyone who has one of the Sears units affected by this recall should contact the nearest Sears store, which will arrange for inspection and free replacement of the unit containing the defect. People who believe they have any of the other detectors under recall should contact BRK to obtain a fact sheet, which gives very specific criteria for identifying potentially defective units, as well as replacement instructions. Additional information concerning the recall can be obtained by contacting BRK Electronics, 780 McClure Avenue, Aurora, Illinois 60507, Attention: Dennis Wm. Clair, Project 749 Director; or by calling toll-free 800/323-9005 and asking for the Project 749 Department.

Hazard

Incorrectly-rated resistors could fail, making the unit inoperable, and may under certain circumstances cause a fire inside the detector.

Remedy Instructions

Anyone who has one of the Sears units affected by this recall should contact the nearest Sears store, which will arrange for inspection and free replacement of the unit containing the defect. People who believe they have any of the other detectors under recall should contact BRK to obtain a fact sheet, which gives very specific criteria for identifying potentially defective units, as well as replacement instructions.

What Should You Do?

Stop using this product immediately. Contact the manufacturer for a Replace at no charge. If you experienced an injury, report it at SaferProducts.gov.

Frequently Asked Questions

Follow the consumer action instructions in the recall notice above. Most recalls require you to stop using the product and contact the manufacturer directly, either by calling the toll-free number listed in the official CPSC notice or by visiting the manufacturer's website. You generally do not need a receipt or original packaging to claim a remedy. The manufacturer is legally required to provide the remedy (Replace) at no cost to you.

If the product caused a fire or burn injury, document the incident with photos and preserve the product if it is safe to do so. Report the incident to the CPSC at SaferProducts.gov and to your local fire department. Contact the manufacturer to inform them of the incident, they are required to track and report injuries to CPSC. You may also want to consult a personal injury attorney, as fire and burn injuries caused by defective products can be grounds for a product liability claim against the manufacturer.

In most cases, no. CPSC-coordinated recall remedies are designed to be accessible without proof of purchase. Manufacturers typically ask consumers to self-certify ownership and may ask for photos of the product or its serial number. Some manufacturers request that you mail in a portion of the product (such as a cut cord or removed component) as proof of disposal. Check the specific remedy instructions for this recall for exact requirements. If you registered your product at the time of purchase, the process is usually even simpler.

If the original manufacturer has gone out of business, the recall remedy may no longer be available through them. In this case, contact CPSC directly at 1-800-638-2772 or cpsc.gov for guidance. If the brand was acquired by another company, the acquiring company may have assumed recall obligations. In some cases where a remedy is unavailable, CPSC advises consumers to safely dispose of the product. If you were injured by the product of a defunct company, consult a product liability attorney, parent companies, distributors, and retailers may still bear liability in some circumstances.