ROBINSON HELICOPTER R44
N. Charleston, SC — February 13, 2012
Event Information
| Date | February 13, 2012 |
| Event Type | ACC |
| NTSB Number | ERA12CA179 |
| Event ID | 20120214X33057 |
| Location | N. Charleston, SC |
| Country | USA |
| Coordinates | 32.87667, -79.95889 |
| Highest Injury | NONE |
Aircraft
| Make | ROBINSON HELICOPTER |
| Model | R44 |
| Category | HELI |
| FAR Part | 091 |
| Aircraft Damage | SUBS |
Conditions
| Light Condition | DAYL |
| Weather | VMC |
Injuries
| Fatal | 0 |
| Serious | 0 |
| Minor | 0 |
| None | 2 |
| Total Injured | 0 |
Event Location
Probable Cause
The flight instructor’s failure to apply power during a practice autorotation in order to arrest a high rate of descent, which resulted in an in-flight collision with terrain.
Full Narrative
The certified flight instructor (CFI) reported that after takeoff, hovering was performed followed by a practice straight-in autorotation with a planned power recovery. The autorotation was initiated between 300 and 400 feet with a 5 to 6 knot tailwind. During the descent they descended faster than anticipated and near the end of the autorotation they “…lost all our lift and started our flare to try and slow us down, but by that point we were too low and still descending sic [to] fast.” The skids hit a mound of dirt and rock which was about 6 to 8 feet above ground level, and he did not apply power, but attempted to back off the mound and turn around. Because the engine was at idle power and decreasing rotor rpm, the helicopter spun and came to rest on its left side. The CFI further reported there was no preimpact mechanic failure or malfunction. Digital pictures provided by the Federal Aviation Administration (FAA) inspector-in-charge depict structural damage to the tailboom, and also the right side of the helicopter in the area of the right aft skid.
About This NTSB Record
This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.