Beech 24
Edgewood, NM — January 4, 2019
Event Information
| Date | January 4, 2019 |
| Event Type | ACC |
| NTSB Number | GAA19CA116 |
| Event ID | 20190104X22004 |
| Location | Edgewood, NM |
| Country | USA |
| Coordinates | 35.09472, -106.16444 |
| Airport | SANDIA AIRPARK ESTATES EAST |
| Highest Injury | NONE |
Aircraft
| Make | Beech |
| Model | 24 |
| Category | AIR |
| FAR Part | 091 |
| Aircraft Damage | SUBS |
Conditions
| Light Condition | DAYL |
| Weather | VMC |
Injuries
| Fatal | 0 |
| Serious | 0 |
| Minor | 0 |
| None | 3 |
| Total Injured | 0 |
Event Location
Probable Cause
The pilot's improper landing flare, which resulted in hard, bounced landing, loss of directional control, runway excursion, and impact with a fence and terrain during an attempted go-around.
Full Narrative
The pilot reported that, while on short final for a precautionary landing to an alternate airport covered with snow, with "extra speed" and about 10 feet above the ground, the airplane suddenly descended, landed hard, and bounced. The right main landing gear tire touched down again, caught the snow, and the airplane veered left. He then initiated a go-around, but the airplane struck a fence and impacted terrain.
The airplane sustained substantial damage to the left wing.
The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.
The automated weather observation station located on an airport about 22 nm away, reported that, about 20 minutes before the accident, the wind was 300° at 6 knots. The pilot reported the wind was blowing hard from 270°. The airplane landed on runway 27.
About This NTSB Record
This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.