AIRBUS/EUROCOPTER AS 350 B3

Full Narrative

On June 11, 2014, about 1140 Alaska daylight time, an Airbus (formerly Eurocopter) AS350 B3 helicopter, N356EV, was substantially damaged when it was involved in an accident near Anchorage, Alaska. The helicopter was operated as a Title 14Code of Federal Regulations Part 91 personal flight.
The first pilot, a certificated flight instructor, reported that he had been hired to ferry the recently-purchased helicopter to Georgetown, Texas. He added that he was providing AS350 B3 helicopter transition training to the second pilot, who was the new owner of the helicopter. The first pilot reported that, after two unsuccessful attempts to start the helicopter, he asked for assistance from a mechanic. The mechanic then contacted the operator’s rotor wing training manager to assist the first pilot in starting the helicopter. He said that while talking with the operator’s rotor wing training manager on a cell phone about the correct starting procedure, the second pilot exited the helicopter, and a mechanic boarded the helicopter and sat down in the right seat. Once the helicopter was successfully started, the mechanic disembarked, and the second pilot again boarded the helicopter, and sat down in the right seat.
The first pilot noted that while the helicopter was operating at flight-idle, the yellow "TWT.GRIP" light was illuminated on the annunciator panel, and he instructed the second pilot to slowly advance the collective-mounted throttle twist grip to the open position until the light went out. He stated that, as the second pilot began to advance the throttle to the open position, the engine speed immediately increased to a very high rpm and the helicopter began to shake violently, and it subsequently rotated about 240° to the left. The pilot performed an emergency engine shutdown, and both pilots exited the helicopter.
The helicopter's fuselage and main rotor drive system sustained substantial damage.
The helicopter was equipped with a Turbomeca Arriel 2B-series turbine engine, with a single channel, full authority digital engine control (FADEC) fuel control system.
The first pilot reported that he had extensive experience in various Airbus/Eurocopter helicopter models, which included about 6,000 flight hours in AS350 B2 helicopters, and about 2,000 flight hours in AS350 B3 helicopters (primarily equipped with the Turbomeca Arriel 2B1-series engine, which have a dual-channel FADEC). However, he could not recall how much experience he had in AS350 B3 helicopters equipped with the Turbomeca Arriel 2B-series engine. He thought he followed the engine start procedures in the helicopter’s flight manual.

The operator’s rotor wing training manager, who assisted the pilot in starting the helicopter, reported, in part: “I sensed when talking with the pilot that he did not have much experience, at least quality experience, with the AS 350 helicopter, especially the AS 350 B3…”

Airbus/Eurocopter Information Notice number 2169-I-67, dated June 6, 2010, specifically alerts operators to the different starting procedures for the AS350 B3 helicopters equipped with 2B-and 2B1-series engines.

A detailed wreckage and engine systems examination revealed no preaccident mechanical failures or malfunctions with the helicopter that would have precluded normal operation. The accident helicopter’s hydro-mechanical metering unit (HMU), digital engine control unit (DECU), and the vehicle and engine multifunction display (VEMD) were removed and shipped to Turbomeca USA’s analytical facility in Grand Prairie, Texas.

The HMU was placed on a test stand, and it operated in accordance with the manufacture’s specifications. The VEMD and DECU were downloaded, which revealed no discernable fault codes of failures associated with the accident start sequence. The VEMD recorded a significant main rotor overspeed limit during the accident.