2008 IC BUS RESB

Navistar is recalling certain model year 2006 through 2009, and 2012 IC CE school buses and certain model year 2006 through 2009, and 2011 through 2013 IC RE school buses manufactured from October 6, 2005, through April 18, 2012, and equipped with C. E. White Inc. brand flip seats.

Navistar is recalling certain model year 2006 through 2011 IC school buses, models CESB, RESB, and FESB, manufactured from June 17, 2004, through October 15, 2009, equipped with I-6 engines within feature codes 12N (PL, PM, PN, PR, PS, PT, PU, PV, SA, SG, SK, SL, SM, SV, SZ, TB, UA, UB, UC, and UD). The high pressure engine oil line may develop a leak or possibly rupture.

NAVISTAR IS RECALLING 1,607 MY 2007 THROUGH 2009 IC BESB, CESB, FESB, AND RESB SCHOOL BUSES MANUFACTURED FROM JANUARY 4, 2006 THROUGH NOVEMBER 15, 2007, EQUIPPED WITH RICON S OR K SERIES WHEELCHAIR LIFTS. THE ANTI-STOW INTERLOCK MAY NOT DETECT THE PRESENCE OF A WHEELCHAIR OR MOBILITY AID USER. THE PRESSURE SENSING SWITCH THAT DETECTS THE PRESENCE OF WEIGHT ON THE PLATFORM WAS NOT ADJUSTED TO THE NECESSARY SENSITIVITY LEVEL. THE LIFT COULD STOW EVEN THOUGH SOMEONE OR SOMETHING IS STILL ON THE LIFT WHICH FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 403, "PLATFORM LIFT SYSTEMS FOR MOTOR VEHICLES."

NAVISTAR IS RECALLING 1,889 IC SCHOOL BUSES MANUFACTURED FROM MAY 4, 2005 THROUGH NOVEMBER 15, 2007, EQUIPPED WITH RICON PLATFORM STYLE WHEELCHAIR LIFTS. THESE LIFTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 403, "PLATFORM LIFT SYSTEMS FOR MOTOR VEHICLES." THE THRESHOLD WARNING SYSTEM MAY NOT DETECT THE PRESENCE OF A WHEELCHAIR OR MOBILITY AID USER IN A CERTAIN SPOT WITHIN THE DEFINED THRESHOLD AREA.

INTERNATIONAL IS RECALLING 34,993 MY 2006-2008 SCHOOL AND TRANSIT BUSES AND HEAVY DUTY TRUCKS/TRACTORS MANUFACTURED BETWEEN JUNE 1, 2006 AND JUNE 28, 2007, EQUIPPED WITH INTERNATIONAL DT466 OR DT570 ENGINES. THE BASE PLATE OF THE ENGINE OIL COOLER MAY CRACK ALLOWING PRESSURIZED OIL TO LEAK INTO THE ENGINE COMPARTMENT.

CERTAIN MY 2007 AND 2008 INTERNATIONAL SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN JANUARY 20 AND SEPTEMBER 28, 2006, EQUIPPED WITH RICON WHEELCHAIR LIFTS . THE LIFT INNER BARRIER INTERLOCK SWITCH SYSTEM MAY NOT DETECT THE PRESENCE OF A PASSENGER ON THE INNER BARRIER AND ALLOW THE PLATFORM TO MOVE DOWN MORE THAN ONE INCH BELOW FLOOR LEVEL WHILE OCCUPIED WHICH DOES NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 403, PLATFORM LIFT SYSTEMS FOR MOTOR VEHICLES.

CERTAIN 2007 AND 2008 MY IC SCHOOL BUSES MANUFACTURED BETWEEN JANUARY 18, 2006, AND JANUARY 17, 2007. THE AIR SUPPLY FITTING MAY SEPARATE FROM THE BASE PLATE, PREVENTING ACTUATION AIR FROM REACHING THE STOP ARM AND/OR CROSSING ARM. THIS CONDITION WILL RESULT IN NON-DEPLOYMENT OF THE STOP ARM AND/OR CROSSING ARM DURING A SCHOOL BUS STOP TO PICK-UP OR DISCHARGE PASSENGERS.

CERTAIN IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN OCTOBER 11, 2005, AND OCTOBER 31, 2006. THESE BUSES HAVE THE FOLLOWING SAFETY ISSUES: IF THE DRIVER'S SEAT IS IN THE HIGHEST AND MOST REAR POSITION, THE BACK OF THE SEAT MAY LEAN AGAINST A BARRIER BEHIND THE SEAT, OR AGAINST THE SEAT BACK. THIS WILL PREVENT THE SEAT BELT FROM RETRACTING WHICH FAILS TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, SEAT BELT ASSEMBLIES. WHEN ADJUST THE SEAT TO A HIGHER POSITION, THE DRIVER MAY PULL THE SEAT PAST THE LAST STOP SO THAT THE SEAT SITS ON THE ADJUSTING PIN, WHICH ALLOWS THE SEAT TO TEETER ON TOP OF THE PIN. IF OVER-TRAVEL OCCURS, THE UPPER SEAT PEDESTAL TUBE COULD SEPARATE FROM THE LOWER PEDESTAL TUBE DURING VEHICLE OPERATION. IF THE DRIVER IS SITTING IN THE DRIVER'S SEAT AND REACHES TO ADJUST THE SEAT HEIGHT, THEIR WEIGHT WILL CAUSE THE SEAT TO DROP, WHICH COULD RESULT IN THEIR HAND BEING PINCHED BETWEEN THE SEAT AND THE LEVER. THE DRIVER'S SEAT IS DIFFICULT TO ADJUST TO A HIGHER POSITION BECAUSE OF THE ADDITIONAL WEIGHT OF THE ALL BELTS TO SEAT (ABTS) DESIGN.