CESSNA 172S
Price, UT — June 27, 2011
Event Information
| Date | June 27, 2011 |
| Event Type | ACC |
| NTSB Number | WPR11CA295 |
| Event ID | 20110628X82743 |
| Location | Price, UT |
| Country | USA |
| Coordinates | 39.55917, -109.70972 |
| Airport | Price Carbon County |
| Highest Injury | NONE |
Aircraft
| Make | CESSNA |
| Model | 172S |
| Category | AIR |
| FAR Part | 091 |
| Aircraft Damage | SUBS |
Conditions
| Light Condition | DAYL |
| Weather | VMC |
Injuries
| Fatal | 0 |
| Serious | 0 |
| Minor | 0 |
| None | 2 |
| Total Injured | 0 |
Event Location
Probable Cause
The pilot's decision to attempt a takeoff at a density altitude outside of the takeoff performance envelope of the aircraft along with using an aircraft flap setting higher than the manufacture's recommended setting for takeoff.
Full Narrative
The pilot took off for a training flight to a dirt strip approximately 50 miles to the east. Upon landing at the strip the pilot decided to initiate a short/soft field take off down the 3,600-foot-long runway. The pilot reported that he took off with 20 degrees of flaps and was never able to get more than 10 feet off the runway surface area. At the end of the runway the pilot noticed two 3-4 foot high dirt berms. He pulled back on the yoke, missing the first berm, but the airplane settled back down and struck the second one. The resulting impact caused the aircraft to nose over and come to a rest inverted. The airplanes pilot operating handbook (POH) states that soft or rough field takeoffs should be performed with no more than 10 degrees of flaps. Furthermore the airport's density altitude at the time of the accident was calculated to be approximately 10,000 feet, which is 2,000 feet above the maximum altitude listed in the takeoff performance charts in the POH. The pilot reported no mechanical issues with the airplane prior to the accident.
About This NTSB Record
This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.