CESSNA 150F

Ferdinand, IN — June 19, 2018

Event Information

DateJune 19, 2018
Event TypeACC
NTSB NumberCEN18TA233
Event ID20180619X83949
LocationFerdinand, IN
CountryUSA
Coordinates38.22055, -86.87305
AirportHuntingburg
Highest InjurySERS

Aircraft

MakeCESSNA
Model150F
CategoryAIR
FAR Part091
Aircraft DamageSUBS

Conditions

Light ConditionNITE
WeatherVMC

Injuries

Fatal0
Serious1
Minor1
None0
Total Injured2

Probable Cause

The pilot's failure to apply carburetor heat in conditions conducive to the accumulation of carburetor icing, which resulted in a total loss of engine power.

Full Narrative

On June 18, 2018, about 2245 eastern daylight time, a Cessna 150F airplane, N3002X, made a forced landing in a parking lot then nosed over in an embankment. The private rated pilot sustained serious injuries and the passenger sustained minor injuries. The airplane sustained substantial damage. The airplane was registered to Gas Publishing LLC and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91 as a personal flight. Night visual meteorological conditions prevailed at the time of the accident and no flight plan had been filed. The flight departed Central Wisconsin Airport (CWA), Mosinee, Wisconsin, about 1700 central daylight time and was en route to Perry County Municipal Airport (TEL), Tell City, Indiana.

After the accident, the pilot reported that before the flight he had filled the long range fuel tanks with 35 gallons of fuel. He stated that about 15 miles north of TEL at 2,500 ft mean seal level, the engine sputtered. The pilot was unable to troubleshoot the engine issue and the engine experienced a total loss of power. He made a forced landing to a paved parking lot between two rows of parked semi-trailers. The airplane landed hard and nosed over when it impacted an embankment (figure 1). The pilot and passenger exited the airplane under their own power. The pilot reported that there were not mechanical malfunctions or failures with the airplane.



Figure 1 – Accident Site (photo courtesy of the Indiana State Police)
The pilot stated to the responding Federal Aviation Administration (FAA) inspector that he did not apply carburetor heat during the troubleshoot. The pilot added that he tried to make it to Huntingburg Airport (HNB), Huntingburg, Indiana, but did not have enough altitude so he made an off-field landing. During the final approach to the paved area the pilot saw power lines and a utility pole; he stated that he banked the airplane to avoid the power lines and pole.

The FAA inspector examined the engine and did not find any anomalies that would have precluded normal operation. There was a smell of aviation fuel at the accident site. An unmeasured amount of fuel remained in the fuel tanks during the recovery of the airplane. Also, fuel was present in the fuel lines to the carburetor.

The carburetor icing probability chart included in Federal Aviation Administration Special Airworthiness Information Bulletin No. CE-09-35, Carburetor Icing Prevention, indicated that the airplane was operating in an area that was associated with a serious risk of carburetor ice accumulation at glide power settings (figure 2).



Figure 2 – Carburetor icing probability chart

About This NTSB Record

This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.

All Aviation Events More in IN