BELL 47G 5

Full Narrative

On April 20, 2016, about 0715 Pacific daylight time, a Bell 47G-5, N6288N, was substantially damaged when it was involved in an accident near San Ardo, California. The pilot received minor injuries. The helicopter was operated as a Title 14 Code of Federal Regulations (CFR) Part 137 agricultural flight.
The pilot stated that he had sprayed five fields that day with no anomalies. After performing a reconnaissance of the sixth field, the pilot was descending the helicopter for a spray pass when the helicopter made a loud noise immediately followed by a vibration. The pilot stated that the helicopter was level but started to roll to one side. He moved the cyclic laterally to correct, but the cyclic was stiffer than normal. The pilot stated that, although the helicopter responded to his inputs, there was a lag in its response that resulted in an overcorrection. He went through two cycles of oscillations before the helicopter was level. He subsequently attempted a run-on landing; however, the helicopter rolled to the left and he was not able to correct with right cyclic before the main rotor blades impacted the ground. The helicopter came to rest on its left side.
A Federal Aviation Administration (FAA) inspector examined the wreckage and identified that the pin of the outboard end torque tube that controlled lateral movement of the swashplate had fractured. The control tube and the upper threaded end were attached to the clevis, which attached to the swashplate and controlled the forward and aft cyclic. The lower end of the control tube remained attached and the upper end had separated.