Cessna 305-A

Mokuleia, HI — February 14, 2008

Event Information

DateFebruary 14, 2008
Event TypeACC
NTSB NumberLAX08LA060
Event ID20080516X00689
LocationMokuleia, HI
CountryUSA
Coordinates21.57944, -158.19722
AirportDillingham Airfield
Highest InjuryNONE

Aircraft

MakeCessna
Model305-A
CategoryAIR
FAR Part091
Aircraft DamageSUBS

Conditions

Light ConditionDAYL
WeatherVMC

Injuries

Fatal0
Serious0
Minor0
None1
Total Injured0

Event Location

Probable Cause

The failure of the left main landing gear strut due to fatigue. Contributing to the failure was the side load placed on the landing gear while making a crosswind landing.

Full Narrative

On February 16, 2008, at 1245 Hawaiian standard time, a Cessna 305-A, N473GF, experienced a left main landing gear collapse during a crosswind landing at Dillingham Airfield, Mokuleia, Hawaii. The airplane was operated by the Honolulu Soaring Club under the provisions of 14 Code of Federal Regulations (CFR) Part 91. The airline transport certificated pilot was not injured, and the airplane was substantially damaged. Visual meteorological conditions prevailed, and no flight plan had been filed. The local flight originated at Dillingham Airfield at 1230.

The pilot reported that he observed the windsocks at each end of runway 8/26, and both indicated tail winds of about 10 knots in either direction. The midfield windsock indicated a direct crosswind from the north. He elected to approach runway 8 and touched down abeam the midfield windsock. Upon touchdown the airplane experienced a left-to-right crosswind, and as the airplane decelerated, the pilot noticed the wind shift to a quartering right tail wind. He elected to execute a go-around. As he advanced the throttle, the engine sputtered, the left main landing gear collapsed, and the airplane ground looped to the left as it approached the runway's edge.

A Federal Aviation Administration inspector examined the left main landing gear spring strut and found that the strut separated where the wheel bolts to the strut. The fracture face of the strut was granular in texture and uniform matte gray in color. When the fracture surface of the landing gear strut section that remained attached to the wheel was more closely examined, it exhibited an approximate 1/16 inch flat dark triangular section at the corner of the mounting bolt hole. The Safety Board Materials Laboratory examination confirmed the presence of a 0.072 inch fatigue crack at this location.

About This NTSB Record

This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.

All Aviation Events More in HI