DUENAS PULSAR III

Hurricane, UT — May 29, 2015

Event Information

DateMay 29, 2015
Event TypeACC
NTSB NumberWPR15LA170
Event ID20150601X03737
LocationHurricane, UT
CountryUSA
Coordinates37.14028, -113.30611
AirportGeneral Dick Stout Field
Highest InjurySERS

Aircraft

MakeDUENAS
ModelPULSAR III
CategoryAIR
FAR Part091
Aircraft DamageSUBS

Conditions

Light ConditionDAYL
WeatherVMC

Injuries

Fatal0
Serious1
Minor0
None0
Total Injured1

Event Location

Probable Cause

An elevated oil temperature and subsequent total loss of engine power for reasons that could not be determined based on the available information.

Full Narrative

HISTORY OF FLIGHTOn May 29, 2015, about 1100 mountain daylight time, an experimental amateur-built Pulsar III, N747N, collided with corral fences during an emergency off airport forced landing at Hurricane, Utah. The private pilot sustained serious injuries; the airplane sustained substantial damage. The pilot/owner was operating the airplane under the provisions of 14 Code of Federal Regulations (CFR) Part 91. The local personal flight departed General Dick Stout Field (1L8) in Hurricane about 1000. Visual meteorological conditions prevailed, and no flight plan had been filed.

The pilot reported that the purpose of the flight was to evaluate the effect of airstream cooling on the engine oil temperature once the airplane reached level flight. The plan was to circle above the airport while climbing to the desired altitude, establish level flight, observe the oil temperature, and land. After takeoff, climb performance and oil temperature were normal. At 5,100 ft msl (airport elevation was 3,347 ft), the pilot began to circle the airport. After three circles, he noticed that the oil temperature was about 220° F, and he began a shallow descent to help cool the engine.

About 4,500 ft, the oil temperature was about 230° F, and the engine shut off. He turned on the auxiliary fuel pump, and attempted to restart the engine. When it did not respond, he began a right turn towards runway 19 at 1L8. The airplane touched down short of the runway, and collided with the corral fences. The pilot sustained a serious head injury, and did not recall anything after the turn toward the airport.

One witness stated that he had observed the takeoff, and watched the airplane complete two climbing turns. He heard a radio transmission from someone asking the pilot if everything was alright. The pilot replied no, he was "dead sticking," which meant to the witness that the engine was not running. The witness observed the airplane was about 1/2 mile from the airport, and the propeller was not turning. He lost sight of the airplane just prior to touchdown. AIRCRAFT INFORMATIONThe engine was an experimental Aeromaxx BB420 H, serial number 11U, rated at 118 hp. Aeromaxx used their own remanufactured and restored Corvair parts to build Corvair engines for homebuilt, experimental aircraft.

The experimental engine was not available for an exam. AIRPORT INFORMATIONThe engine was an experimental Aeromaxx BB420 H, serial number 11U, rated at 118 hp. Aeromaxx used their own remanufactured and restored Corvair parts to build Corvair engines for homebuilt, experimental aircraft.

The experimental engine was not available for an exam.

About This NTSB Record

This aviation event was investigated by the National Transportation Safety Board (NTSB). NTSB investigates all U.S. civil aviation accidents to determine probable cause and issue safety recommendations to prevent future accidents.

All Aviation Events More in UT