ENGINE AND ENGINE COOLING:ENGINE
Lotus Cars USA, Inc. (Lotus) is recalling certain model year 2008-2011 Elise and Exige vehicles manufactured from November 2007 to July 2011, and 2011 Evora vehicles manufactured September 2010 through September 2011. The oil cooler hose may detach from its fitting.
Remedy: Lotus will notify owners, and dealers will replace the oil cooler hose fittings on the Elise and Exige vehicles and will replace the oil cooler hose assemblies on the Evora vehicles, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Lotus at 1-800-245-6887. Lotus' number for this recall is 201401R (Elise/Exige), and 2014/02R (Evora). Note: This recall is an expansion of recalls 11V-510 and 13V-041.
860 vehicles affected
ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS
Lotus Cars USA, Inc. is recalling certain model year 2011 Evora supercharged vehicles equipped with a manual transmission and manufactured September 2010 through September 2011. The engine oil cooler hose may chafe and rupture resulting in oil loss.
Remedy: Lotus will notify owners and dealers will repair the vehicles free of charge. The recall began on December 11, 2013. Owners may contact Lotus at 1-770-476-6564. Lotus' campaign number is 2013/03R.
80 vehicles affected
ENGINE AND ENGINE COOLING
Lotus is recalling certain model year 2011 Evora supercharged vehicles manufactured from February 2011 through September 2011, equipped with a three-piece oil feed pipe with a flexible hose section. This engine mounted oil feed pipe, used to supply oil to the engine cylinder head, can rupture.
Remedy: Lotus will notify owners, and dealers will replace the oil feed pipe free of charge. The safety recall began on December 10, 2012. Owners may contact Lotus at 1-800-245-6887.
80 vehicles affected
Rear upper control arm failure. A crack develops along a casting line, which then allows the upper bushing to move within the control arm. This bushing is pressed into the control arm, and is not supposed to move. Because the hub was allowed to tilt forward due to the bushing not being held firmly by the control arm, the outer CV boot was allowed to contact the lower spring perch, which then burned a hole in the CV boot, allowing all its grease to escape. This scenario can generate an excessive amount of heat and/or wear in that joint, leading to axle failure.